Therma

  • HL56000

Therma

IN/OUT BOARD CLIMATE CONTROL

Description

FUNCTION
Therma permits temperature control in the home using the appropriate 1 module thermostat or simple NTC analogue probes working solenoid valves and fan coils.

CONNECTIONS
Therma has 8 digital inputs, 4 Master analogue temperature sensor inputs, 4 relay outputs and 4 0-10V outputs for control, 230V~ mains power supply and RS485 communication port for programming using Lapis software.

TECHNICAL CHARACTERISTICS
Therma is an advanced board used to manage and adjust the boiler, solenoid valves and fan coils in 4 separate areas. It can operate standalone or controlled via RS485 bus, using Vesta and Visus software. The board is set up for fastening with DIN guide (Master type) control panel where it occupies 6.5 modules and, thanks to the optional side rings, can be screwed onto junction boxes or plasterboard walls. All connections are made using extractable printed terminal blocks to facilitate wiring and replacement. The 8 digital inputs can be individually programmed differently in order to manage heating commands, solenoid valves, fan coils with complete or limited temperature control (e.g. functions +-1/3° for hotels). Temperature sensor inputs allow for the measurement of the temperature in the individual areas of interest. Adjustment takes place by means of the 4 12A resistive relays (maximum total load 3 kVA) that allow for turning on and off, and the four adjustment channels with 0-10V output. The relays may be used to vary the speed (rate of flow) of fan coils requiring remote selection through contacts. Therma with NTC probes behaves like a 1 module thermostat on Visus, Tosca and Sidera.
Therma is supplied pre-programmed with the “UNA heat regulation valve” function on the first four inputs, and can be set up as you wish using Lapis programming software.

CODES
HL56000 230V~ Therma (package of 1pc.)
HL56500 127V~ Therma (package of 1pc.)